Corrosion of Ceramic and Carbon-Based Materials in FLiNaK

Molten salt nuclear fast nuclear reactor (MSNFR) is one of the prospective design in frame of Generation IV concept. This technology is also required for reprocessing of spent nuclear fuel (SNF) in molten salts to extract valuable components. Recycling SNF consists of extraction uranium and plutonium with the disposal of minor actinides and fission products. These stages need the materials that retain their corrosion and mechanical properties for long time under the influence of high temperatures, radiation fields and contact with molten salts. Various steels and alloys were widely studied to assess their use under such extreme conditions. Alternative materials include ceramics, composite and carbon materials, which have high corrosion resistance in various media and can be used up to 1000 °C. In the present work the corrosion and mechanical properties of nitride ceramics (Si 3 N 4 and BN) and carbon-based materials (carbon-carbon composite material (C/C) and high-density carbon) were studied in a molten mixture of lithium, sodium, and potassium fluorides (FLiNaK) in the temperature range of 550–750 °C under inert atmosphere. Corrosion tests were performed under static conditions, and the duration of each test was 100 h to enable the comparison of the experimental data. It was found that carbon-containing materials (C/C and high-density carbon) showed high corrosion resistance in the melt. C/C samples had lower corrosion rates (less than 0,1 mm/year in the entire temperature range), while the high-density carbon showed better mechanical properties. The main disadvantage of these materials is their impregnation by molten salt due to relative high porosity. However, C/C composite and high-density carbon are promising structural materials for salt media based on FLiNaK in the selected temperature range. Tested nitride ceramics (BN, Si 4 N 3 ) demonstrated relatively low corrosion resistance in fluoride systems compare to carbon-containing and metallic materials. The corrosion rates of these materials in FLiNaK exceeded the value of 1 mm/year. The plastic properties of nitride ceramics were also poor. Possible application of such materials for MSNFR and SNF reprocessing is under further investigation.