A 6.6‐kV transformerless STATCOM based on a five‐level diode‐clamped converter. Experiments using a three‐phase laboratory model rated at 200 V and 10 kVA

This paper discusses a 6.6‐kV transformerless STATCOM intended for installation on industrial and utility distribution systems in the near future. In addition, this paper provides experimental results obtained from a laboratory model rate at 200 V and 10 kVA. The authors propose such a control method as to superimpose a sixth harmonic zero‐sequence component on each of three‐phase voltage references. This helps to stabilize the voltage of the inner midpoint in the DC link. As a result, the laboratory model installs two bidirectional buck‐boost choppers on the DC link for the purpose of stabilizing the voltages of two outer midpoints. Experimental results obtained from the laboratory model verify the validity of the system design, giving promise of the viability of the 6.6‐kV transformerless STATCOM. © 2009 Wiley Periodicals, Inc. Electr Eng Jpn, 168(2): 60–68, 2009; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20733