Publications

The aim of the research was the analysis of yoghurts enriched with blue honeysuckle berries dry polyphenolic extract and new preparation of resistant starch. The additives were introduced individually at concentration 0.1% (w/v) and in mixture at final concentration of 0.1 and 0.2% of both components. Yogurt microflora, pH, and its physicochemical and antioxidant properties were examined over 14 days of storage under refrigerated conditions. Studies showed that both substances can be successfully used in yoghurt production. Yoghurt microflora es. S. thermophilus and Lb. delbrueckii subsp. bulgaricus counts appeared to be higher in samples supplemented with these additives comparing to control yoghurt by 3–8%. More stimulating effect on their growth, especially on S. thermophilus, revealed resistant starch. Addition of this polysaccharide improved also the rheological properties of yogurts, which showed higher viscosity than samples produced without it. Addition of honeysuckle berries preparation significantly influenced the yogurts’ color, giving them deep purple color, and their antioxidant potential. During storage, contents of anthocyanin and iridoid compounds were decreasing, but antioxidant activity in the products remained stable.

To date, only a few studies focused on carbon monoxide (CO) production during waste composting; all targeted on CO inside piles. Here, the CO net emissions from compost piles and the assessment of worker’s occupational risk of exposure to CO at large-scale composting plants are shown for the first time. CO net emissions were measured at two plants processing green waste, sewage sludge, or undersize fraction of municipal solid waste. Effects of the location of piles (hermetised hall vs. open yard) and turning (before vs. after) were studied. Higher CO net emission rates were observed from piles located in a closed hall. The average CO flux before turning was 23.25 and 0.60 mg‧m-2‧h-1 for hermetised and open piles, respectively, while after – 69.38 and 5.11 mg‧m-2‧h-1. The maximum CO net emissions occurred after the compost was turned (1.7x to 13.7x higher than before turning). The top sections of hermetised piles had greater CO emissions compared to sides. Additionally, 5% of measurement points of hermetised piles switched to ‘CO sinks’. The 1-h concentration in hermetised composting hall can reach max. ~50 mg CO∙m-3 before turning, and >115 mg CO∙m-3 after, exceeding the WHO thresholds for a 1-h and 15-min exposures, respectively.

New technologies to valorize refuse-derived fuels (RDFs) will be required in the near future due to emerging trends of (1) the cement industry’s demands for high-quality alternative fuels and (2) the decreasing calorific value of the fuels derived from municipal solid waste (MSW) and currently used in cement/incineration plants. Low-temperature pyrolysis can increase the calorific value of processed material, leading to the production of value-added carbonized solid fuel (CSF). This dataset summarizes the key properties of MSW-derived CSF. Pyrolysis experiments were completed using eight types of organic waste and their two RDF mixtures. Organic waste represented common morphological groups of MSW, i.e., cartons, fabrics, kitchen waste, paper, plastic, rubber, PAP/AL/PE composite packaging (multi-material packaging also known as Tetra Pak cartons), and wood. The pyrolysis was conducted at temperatures ranging from 300 to 500 °C (20 °C intervals), with a retention (process) time of 20 to 60 min (20 min intervals). The mass yield, energy densification ratio, and energy yield were determined to characterize the pyrolysis process efficiency. The raw materials and produced CSF were tested with proximate analyses (moisture content, organic matter content, ash content, and combustible part content) and with ultimate analyses (elemental composition C, H, N, S) and high heating value (HHV). Additionally, differential scanning calorimetry (DSC) and thermogravimetric analyses (TGA) of the pyrolysis process were performed. The dataset documents the changes in fuel properties of RDF resulting from low-temperature pyrolysis as a function of the pyrolysis conditions and feedstock type. The greatest HHV improvements were observed for fabrics (up to 65%), PAP/AL/PE composite packaging (up to 56%), and wood (up to 46%).

Chlortetracycline and sulfadiazine are commonly used in animal husbandry, which can be found in cow manure. Anaerobic digestion is the most popular technic for obtaining biomethane from substrates like cow manure and other organic materials. However, the presence of an antibiotic in the feedstock can adversely affect biomethane yields. In this paper, the influence of chlortetracycline and sulfadiazine affecting biomethane yield for 21 days lasting co-fermentation of cow manure and apple pomace was determined. The doses between 10-1000 mg×kg-1 of chlortetracycline and 10-500 mg×kg-1 of sulfadiazine were studied. The kinetics parameters of biomethane production were determined according to the modified Gompertz model. The experiments showed that chlortetracycline had an inhibitory effect on biomethane production, even at high doses, e.g., 1000 mg×kg-1 can completely stop biomethane production after 6 days of the process. In this case, the biomethane yield had been reduced by 32.3%. In contrast, sulfadiazine did not affect biomethane production. However, the kinetics study revealed that the highest dose of sulfadiazine 500 mg×kg-1 decreased the maximum biomethane potential by 13.9%. Obtained results showed that anaerobic digestion performance may be affected by high doses of antibiotics, therefore the proper screening of the manure source before entering the biogas plant is recommended. Lack of the influence of low doses of antibiotics may indicate the development of antibiotic-resistant genes in the activated sludge of biogas plants. This phenomenon should be studied both as it may have importance for biogas plant performance and spreading these genes in the environment after digestate field application.

The release of hazardous volatile organic compounds (HVOCs) from biochar poses a potential threat to both human health and the environment. This study investigates how low pyrolysis temperature (HTT) and the chemical characteristics of lignocellulosic biomass, expressed as the carbon-relative molar mass (CRMM) index (g·mol^-1), influence the release of hazardous volatile compounds from biochar. A total of 204 biochar samples were produced from pure biomass components: lignin (L), cellulose (C), hemicellulose (H) and their mixtures, and analyzed using stepwise multiple regression, agglomerative hierarchical clustering, principal component analysis (PCA), and regression decision trees. The analysis included both qualitative and quantitative assessments of HVOCs. Qualitative results indicated the presence of HVOCs, but quantitative patterns were nonlinear and inconsistent with expected trends. Decision tree analysis showed that the highest release occurred either at very high CRMM values (>34 g mol^-1) or at low-temperature conditions (200-325 °C) with low CRMM. The lowest release was associated with temperatures 350-425 °C and elevated CRMM. The results emphasize the need to consider both process and substrate parameters when assessing release risks, providing a new approach to evaluating the safety of biochar in the context of environmental and human health protection. To our knowledge, this is the first study to apply decision tree regression to model HVOC release from biochar based on CRMM and pyrolysis conditions.

Advanced technologies call for composting indoors for minimized impact on the surrounding environment. However, enclosing compost piles inside halls may cause the accumulation of toxic pollutants, including carbon monoxide (CO). Thus, there is a need to assess the occupational risk to workers that can be exposed to CO concentrations > 300 ppm at the initial stage of the process. The objectives were to (1) develop a model of CO accumulation in the headspace of the bioreactor during organic waste composting and (2) assess the impact of headspace ventilation of enclosed compost. The maximum allowable CO level inside the bioreactor headspace for potential short-term occupational exposure up to 10 min was 100 ppm. The composting was modeled in the horizontal static reactor over 14 days in seven scenarios, differing in the ratio of headspace-to-waste volumes (H:W) (4:1, 3:1, 2:1, 1:1, 1:2, 1:3, 1:4). Headspace CO concentration exceeded 100 ppm in each variant with the maximum value of 36.1% without ventilation and 3.2% with the daily release of accumulated CO. The airflow necessary to maintain CO < 100 ppmv should be at least 7.15 m3·(h·Mg w.m.)−1. The H:W > 4:1 and the height of compost pile < 1 m were less susceptible to CO accumulation.

In this study, 12 organic waste materials were subjected to TG/DTG thermogravimetric analysis and DSC calorimetric analysis. These analyses provided basic information about thermochemical transformations and degradation rates during organic waste pyrolysis. Organic waste materials were divided into six basic groups as follows: paper, cardboard, textiles, plastics, hygiene waste, and biodegradable waste. For each group, two waste materials were selected to be studied. Research materials were (i) paper (receipts, cotton wool); (ii) cardboard (cardboard, egg carton); (iii) textiles (cotton, leather); (iv) plastics (polyethylene (PET), polyurethane (PU)); (v) hygiene waste (diapers, leno); and (vi) biodegradable waste (chicken meat, potato peel). Waste materials were chosen to represent the most abundant waste that can be found in the municipal solid waste stream. Based on TG results, kinetic parameters according to the Coats–Redfern method were determined. The pyrolysis activation energy was the highest for cotton, 134.5 kJ × (mol∙K)−1, and the lowest for leather, 25.2 kJ × (mol∙K)−1. The DSC analysis showed that a number of transformations occurred during pyrolysis for each material. For each transformation, the normalized energy required for transformation, or released during transformation, was determined, and then summarized to present the energy balance. The study found that the energy balance was negative for only three waste materials—PET (−220.1 J × g−1), leather (−66.8 J × g−1), and chicken meat (−130.3 J × g−1)—whereas the highest positive balance value was found for potato peelings (367.8 J × g−1). The obtained results may be applied for the modelling of energy and mass balance of municipal solid waste pyrolysis.

Vitellogenin (Vt) is considered the primary protein precursor of egg yolk, serving as a source of protein- and lipid-rich nutrients for the developing embryo. However, recent research has revealed that the functions of Vt and Vt-derived polypeptides, such as yolkin (Y) and yolk glycopeptide 40 (YGP40), extend beyond their nutritional roles as a source of amino acids. Emerging evidence has demonstrated that both Y and YGP40 possess immunomodulatory properties and can contribute to host immune defenses. Additionally, Y polypeptides have been shown to exhibit neuroprotective activity, participating in the modulation of neurons' survival and activity, inhibiting neurodegeneration processes, and improving cognitive functions in rats. These non-nutritional functions not only enhance our understanding of the physiological roles of these molecules during embryonic development but also offer a promising basis for the potential application of these proteins in human health.

The proof-of-the-concept of application of low-temperature food waste biochars for the anaerobic digestion (AD) of food waste (the same substrate) was tested. The concept assumes that residual heat from biogas utilization may be reused for biochar production. Four low-temperature biochars produced under two pyrolytic temperatures 300 °C and 400 °C and under atmospheric and 15 bars pressure with 60 min retention time were used. Additionally, the biochar produced during hydrothermal carbonization (HTC) was tested. The work studied the effect of a low biochar dose (0.05 g