Flexural capacity and local buckling half-wavelength of high strength steel tubular beams under moment gradients: An experimental study

An experimental investigation into the effect of moment gradients on the flexural behaviour of hot-rolled high strength steel square hollow section (SHS) beams is presented in this paper. In total, 20 beam specimens in steel grades S690 and S770, and with cross-sections spanning from Class 2 to Class 4 based on the Eurocode 3 slenderness limits, were tested under three- and four-point bending. In the three-point bending tests, the beam spans were varied to achieve a range of moment gradients; the influence of different stiffening arrangements at the loading point was also considered. Local geometric imperfections were measured by means of 3D laser-scanning prior to testing and digital image correlation (DIC) was adopted to monitor the displacement and strain fields at critical regions and to assess the local buckling half-wavelengths of the test specimens for which a consistent measurement approach was proposed. The measured local buckling half-wavelengths were compared against the elastic local buckling half-wavelengths calculated using the finite strip method. It was observed that while the measured local buckling half-wavelengths remained approximately constant up to first yield, a significant reduction in half-wavelength was observed with increasing moment due to the non-uniform spread of plasticity. The comparisons also revealed that the local buckling half-wavelengths reduced with both the presence of moment gradients and intermediate stiffeners, with a new parameter proposed to quantify the local moment gradient. It was shown from the tests that the specimens subjected to moment gradients, despite the presence of shear, exhibited higher ultimate moment capacities (up to 10.5% for stiffened specimens and 3.4% for unstiffened specimens) than those subjected to uniform moments. This is attributed to the delay in the local buckling of the critical cross-section of beams under moment gradients due to the restraint provided by the less heavily stressed adjacent cross-sections.