Elastic local post-buckling of elliptical tubes

The elastic local post-buckling behaviour of elliptical tubes under compression is analysed in this paper. A brief outline of the local, distortional and global buckling behaviour of EHS tubes is firstly provided, where it is shown that local buckling modes govern the stability of short to intermediate length tubes while distortional modes control the stability of intermediate length to moderately long tubes and global buckling dominates the behaviour of longer tubes. Following this, an in-depth numerical study employing shell finite element modelling, of the elastic local post-buckling behaviour of compressed elliptical hollow section (EHS) tubes is presented. It is concluded that EHS tubes with a low to moderate aspect ratio can support loads up to their limit loads but are imperfection sensitive (shell-type behaviour), while EHS tubes with a moderate to high aspect ratio can carry loads higher than their limit loads (plate-type behaviour) and are imperfection insensitive. The slope of the ascending post-buckling path increases with the EHS aspect ratio and can reach values up to 40% of the slope of the linear primary path. The bound imperfection amplitude concept, separating the imperfection amplitude ranges where the EHS tube is sensitive and insensitive, is proposed. It is also found that, for increasing EHS aspect ratio, the compressive stresses grow and accumulate near the zones of minimum radius of curvature while the zones of maximum radius of curvature possess an approximately uniform and relatively low compressive stress level. Therefore, it is expected that an approach based on the effective width concept widely used for the evaluation of the strength of flat plates may be adapted to the design of EHS tubes with moderate to high aspect ratios.