Effect of microstructure on mixed‐mode (mode I + II), high‐cycle fatigue thresholds in a Ti‐6Al‐4V alloy is reported over a range of crack sizes from tens of micrometers to in excess of several millimeters. Specifically, two microstructural conditions were examined—a fine‐grained equiaxed bimodal structure (grain size ∼20 µm) and a coarser lamellar structure (colony size ∼500 µm). Studies were conducted over a range of mode‐mixities, from pure mode I (Δ K II /Δ K I = 0) to nearly pure mode II (Δ K II /Δ K I ∼ 7.1), at load ratios (minimum load/maximum load) between 0.1 and 0.8, with thresholds characterized in terms of the strain‐energy release rate (Δ G ) incorporating both tensile and shear‐loading components. In the presence of through‐thickness cracks—large (> 4 mm) compared to microstructural dimensions—significant effects of mode‐mixity and load ratio were observed for both microstructures, with the lamellar alloy generally displaying the better resistance. However, these effects were substantially reduced if allowance was made for crack‐tip shielding. Additionally, when thresholds were measured in the presence of cracks comparable to microstructural dimensions, specifically short (∼200 µm) through‐thickness cracks and microstructurally small (< 50 µm) surface cracks, where the influence of crack‐tip shielding would be minimal, such effects were similarly markedly reduced. Moreover, small‐crack Δ G TH thresholds were some 50–90 times smaller than corresponding large crack values. Such effects are discussed in terms of the dominant role of mode I behaviour and the effects of microstructure (in relation to crack size) in promoting crack‐tip shielding that arises from significant changes in the crack path in the two structures.
Discussion(0)
No comments yet. Be the first to comment.