Behavior analysis of FRP tube/filling strengthened steel members under axial compression

This study presents a new fiber reinforced polymer tube/filling strengthening method (i.e., FRP tube/filling strengthening) that creates a new composite compression member with a novel mechanical behavior, “bilinear behavior.” Previous experimental and theoretical studies have been conducted based on the ultimate state of the section. To thoroughly study the stiffness and entire loading process of this novel member, finite element analysis (FEA) models are built in this paper. First, the model development process considers the initial defections and interface properties, and these models are verified by the experimental results. Two models of typical load-axial displacement curves describe the experimental results: a Bilinear model and a Trilinear model. Second, finite element modeling (FEM) is used to conduct a parametrical analysis that considers 7 parameters, and the results identify the mechanism of the strengthened member. Specifically, the Bilinear model corresponds to an unreinforced or relatively weakly reinforced specimen, and the Trilinear model corresponds to a relatively strongly reinforced specimen. If the exterior restraint system is weak, then the core steel buckles and subsequently yields; this behavior is described by the Bilinear model. If the exterior restraint system is strong (e.g., the length or the bending stiffness of the exterior restraint system is great), then the specimen can continue to bear a higher force after steel yielding until elastic-plastic buckling occurs; this behavior is described by the Trilinear model. Third, the FEA results and previous experimental and theoretical studies are used to obtain the stiffness and load-axial displacement curves, which are helpful for the design process. In general, relatively accurate FEA models are built in this paper that are capable of describing the mechanical behaviors of the novel member.