A wind tunnel study was conducted to determine the optimal design features of a large, open-top chamber, as needed for pollution exposure studies on mature trees. An optimally-designed, open-top chamber must minimize the incursion of ambient air through its opening and maintain a uniform treatment concentration throughout the chamber. The design features of interest are the diameter and height of the chamber and the deflection angle and opening size of any frustum that may be mounted on top of a model chamber. Design specifications depend on the turbulence regime about the chamber, which is influenced by the nature of the surrounding vegetation. Consequently, our investigation was performed on scale-model, open-top chambers in a wind tunnel populated with a model coniferous forest. Turbulence measurements demonstrated the similarity between the turbulence regime of the model and a natural forest. A hydrocarbon tracer was injected into the wind tunnel flow to characterize chamber performance. The main design features of open-top chambers are the velocity of air exiting through the top and the relationship between the length scale of the turbulence and the diameter of the chamber opening. As exit velocities increase, the proportion of eddies with sufficient force to penetrate into the chamber decrease. Therefore, for equal volumetric air flows, smaller opening sizes increase the exit velocities and reduce the number and extent of ambient air incursions. Almost total exclusion of ambient air is achieved as the exit velocity of the air exceeds the magnitude of one standard deviation of the vertical wind velocity measured at the chamber top. The incursion of ambient air is also reduced when the diameter of the chamber opening is smaller than the characteristic length scale of the turbulence, a measure of mean eddy size. Frusta deflect air flow over the chamber. Three prototypes, with 30−, 45− and 60-degree angles were tested. A 30-degree frustum slightly improves the performance of the chamber and is more effective in preventing ambient air from entraining into the chamber opening than frusta with either a 45− or 60-degree angle. A flatter frustum allows for a smoother transition in the wind velocity streamline and is less apt to cause wake turbulence, as is the case with steeper frusta. Knowledge of the turbulence characteristics of plant canopies are readily available in the literature and can aid scientists and engineers in designing the optimal chamber and frusta dimensions for their particular application. Therefore, the empirical approach to chamber design can be avoided, and substantial savings can be realized.
Discussion(0)
No comments yet. Be the first to comment.