A Method for Squareness Error Verification on a Coordinate Measuring Machine

Jean-pierre Kruth; Lin Zhou; Christophe Van Den Bergh; Paul Vanherck

doi:10.1007/s00170-002-1408-x

A Method for Squareness Error Verification on a Coordinate Measuring Machine

The International Journal of Advanced Manufacturing Technology 21(10-11): 874-878

Article 2003 English

Abstract

1 min read

The face diagonal method for squareness error measurement is already well established. Because it is easy to apply, this method is widely used in CMMs (coo

Discussion(0)

No comments yet. Be the first to comment.

Related publications

Article1994

Self-calibration method and software error correction for three-dimensional coordinate measuring machines using artefact measurements

Jean-pierre Kruth, Paul Vanherck, L. De Jonge

Measurement

Chapter in a book1993

Self-Calibration Method for Three Dimensional Coordinate Measuring Machines Using a Ball Plate

L. De Jonge, Jean-pierre Kruth

Article2003

Behaviour and accuracy specification - study on an LED-CMOS camera 3D measuring sys tem

Jean-pierre Kruth, Liang Zhou, Paul Vanherck

Article2017

M/T method based incremental encoder velocity measurement error analysis and self-adaptive error elimination algorithm

Article2001

Coorecting steady-state temperature influences on coordinate measuring machines

Jean-pierre Kruth, Christophe Van Den Bergh, Paul Vanherck

Journal of Manufacturing Systems